SLaPPiE Hi, lots of questions...How did you power the board? Through the vcc on the pwm connector with full battery voltage?Did the board come flashed with betaflight 3.2? If not, did you short the boot pin to the 3.3v pin next to it to enter boot mode?
رد 29/09/2017Jhawk Hi MattThus total how many UARTS are there on the board ?TxJT
رد 02/10/2017tykkah It says OMNIBUSF4SD target
رد 14/10/2017esunder How do you flash this board with BF3.2? I assume I need to install a driver, boot the FC in \"boot mode\", and then flash? What is the correct driver and how do I get it into boot mode? Right now when I power it via usb, I get 1 solid red light and a blinking blue light.Thanks!
رد 28/10/2017Andrewjd24 you can do a later flash... Just chose legacy.
رد 12/01/2020شركتنا | اتصل بنا | الدفع و الشحن | برامج الشراكة |
---|---|---|---|