Хороший блок питания 12В 6А. Работает стабильно, охлаждение достаточное. Из минус только что писк при работе.

Хороший блок питания 12В 6А. Работает стабильно, охлаждение достаточное. Из минус только что писк при работе.

Хороший блок питания 12В 6А. Работает стабильно, охлаждение достаточное. Из минус только что писк при работе.

Asking for 6A with electronic load, works fine (the drop voltage (11.7 instead of 12) is explained by the 1.5m , 0.75mm² cable i used to link the board and my device. In theory the cable adds 0.034Ohm resistance x12v ) 12.2 is what my multimeter say when i look directly at the "plug" with probe I did not made a long term run at 6a to monitor t° increase. I noticed that the 2 capacitor on the 12v side are very close to the heat sink...

Asking for 6A with electronic load, works fine (the drop voltage (11.7 instead of 12) is explained by the 1.5m , 0.75mm² cable i used to link the board and my device. In theory the cable adds 0.034Ohm resistance x12v ) 12.2 is what my multimeter say when i look directly at the "plug" with probe I did not made a long term run at 6a to monitor t° increase. I noticed that the 2 capacitor on the 12v side are very close to the heat sink...

Asking for 6A with electronic load, works fine (the drop voltage (11.7 instead of 12) is explained by the 1.5m , 0.75mm² cable i used to link the board and my device. In theory the cable adds 0.034Ohm resistance x12v ) 12.2 is what my multimeter say when i look directly at the "plug" with probe I did not made a long term run at 6a to monitor t° increase. I noticed that the 2 capacitor on the 12v side are very close to the heat sink...