produto de boa qualidade, bons resultados de impressao. Good quality product, good printing results.   .

produto de boa qualidade, bons resultados de impressao. Good quality product, good printing results.   .

produto de boa qualidade, bons resultados de impressao. Good quality product, good printing results.   .

Отличный пластик для 3D принтера, буду заказывать еще.

Отличный пластик для 3D принтера, буду заказывать еще.

Отличный пластик для 3D принтера, буду заказывать еще.

I made a test piece with this filament and it is a really good filament.

I made a test piece with this filament and it is a really good filament.

I made a test piece with this filament and it is a really good filament.

Отличный пластик для 3д принтера, заказываю второй раз, печатает от190 градусов. Пришел в вакуумной упаковке с силикагель за 10 дней.

Отличный пластик для 3д принтера, заказываю второй раз, печатает от190 градусов. Пришел в вакуумной упаковке с силикагель за 10 дней.

Отличный пластик для 3д принтера, заказываю второй раз, печатает от190 градусов. Пришел в вакуумной упаковке с силикагель за 10 дней.

Good quality product, good printing results.   .produto de boa qualidade, bons resultados de impressao.

Good quality product, good printing results.   .produto de boa qualidade, bons resultados de impressao.

Good quality product, good printing results.   .produto de boa qualidade, bons resultados de impressao.

Brass is not really brass but bronze. Other than that it's quite good. I managed to get a print at 0.09mm perfectly. You need to increase your extrusion in order to succeed. Also it needs fan to be on, but not at too high. High fan causes stringing. Finally, the filament can hold tons of heat and it takes time to cool, this means you have print quite slowly.

Brass is not really brass but bronze. Other than that it's quite good. I managed to get a print at 0.09mm perfectly. You need to increase your extrusion in order to succeed. Also it needs fan to be on, but not at too high. High fan causes stringing. Finally, the filament can hold tons of heat and it takes time to cool, this means you have print quite slowly.

Brass is not really brass but bronze. Other than that it's quite good. I managed to get a print at 0.09mm perfectly. You need to increase your extrusion in order to succeed. Also it needs fan to be on, but not at too high. High fan causes stringing. Finally, the filament can hold tons of heat and it takes time to cool, this means you have print quite slowly.

Godt produkt. Fornøyd.

Godt produkt. Fornøyd.

Godt produkt. Fornøyd.

Marchandise conforme, Livraison rapide, pas de problèmes. Rest à tester sur ma Makerbot 2+

Marchandise conforme, Livraison rapide, pas de problèmes. Rest à tester sur ma Makerbot 2+

Marchandise conforme, Livraison rapide, pas de problèmes. Rest à tester sur ma Makerbot 2+

in Ordnung

in Ordnung

in Ordnung

top

top

top