KY-008 ÐазеÑнÑй ÑÑанÑмиÑÑÐµÑ Ð¼Ð¾Ð´ÑÐ»Ñ AVR PIC
Часть обзора переведена автоматически.
but nothing too bad. what is marked with (-) should go to pwm pin as signal, middle pin should go to ground from external power source (MB102 is great for that!) and what is marked as (S) becomes + from external 5v power. once this is connected laser is nice and precise.
It's a great module but the laser itself is not really aligned with the board . It goes a little bit on the right ! That's the right way to connect it to your arduino : "S" : signal _connected to a digital pin "-" : Connected to the ground Middle pin : connected to 5 volt
хорошо, но gnd и 5v смешиваются
good quality It will be tested soon
Very small and cheap module for arduino.
This is very good priced item. I suggest buying it. Delivered fast and very useful.
эти работы великий и вкус удивительный
Отличный маленький модуль, хотя область разметки выключена. Gnd получает 5v S на питание 0v для постоянного состояния. При необходимости механизм фокусировки работает достаточно хорошо для широкого луча.
On Arduino UNO you can plug directly into GND 13 (put the middle pin in there) and use Pin 12 for the S pin.
Now all I need is the sharks on which to put this laser beam.