Comentarios de Clientes

4.2 fuera de 5
Ver todos 5 comentarios
Escribe un Comentario
  • Todos los comentarios (5)
  • Imagen (0)
  • Video (0)
  • Todas Las Estrellas
    • Todas Las Estrellas(5)
    • 5 Estrellas(2)
    • 4 Estrellas(2)
    • 3 Estrellas(1)
    • 2 Estrellas(0)
    • 1 Estrellas(0)
Ordenar por:
Comentarios Recomendados
  • Comentarios Recomendados
  • Muy útil
  • Más Reciente
Reseñas solo de tu país (United States)
|
Mostrar original

Una parte de la reseña se ha traducido automáticamente.

  • 14/01/2014

    This is a decent light that's bright and simple to attach and detach to the bike without hardware. I like the fact that there is no mounting hardware which can break (which happens with some plastic mounts). It isn't clear in the description but there are 5 white lights on the front and 1 red light on each side (2 total). The red lights are a nice touch if you're using this for a rear light. The lights are quite bright and should make the bike very visible. The light comes apart in 2 pieces. The silicone cover and the plastic interior. To install the batteries, you stretch the silicone cover and pull the interior plastic out. My only real complaint is that there are a few exposed wires attached to the plastic interior that are exposed. If you're not careful removing and inserting the piece, you might disconnect a wire as the silicone cover is stretched over it. The silicone cover creates a pretty tight seal but may not be 100% water tight.

    Comentarios (1)
    Mostrar original
  • 02/10/2020

    entregada después de mucho tiempo. Muy bien, gracias.

    Comentarios
    Mostrar original
  • 25/10/2019

    muy buen producto

    Comentarios
    Mostrar original
  • 22/07/2019

    It is only suitable for the front of a bike, and fitting batteries is a bit difficult as the silicone cover must be stretched quite strongly. The fit of the cover is less than precise, but I haven’t used it in wet weather yet so I’m not sure about water resistance... but it should be ok.

    Comentarios
    Mostrar original
  • 25/03/2016

    Pour mettre les piles il faut enlever la coque plastique. 1° démontage l'interrupteur de mise en marche dessoudé (mais était-il soudé?). Je remet en place l'interrupteur seul les leds rouges latérales fonctionnent. Les 5 leds blanches ne fonctionnent pas. Il va donc falloir démonter. Le capot transparent se démonte. Il y a 4 emplacements pour les 4 vis de fixation il n'y en a que 2 vis. De plus les deux vis présentes ont cassé le filetage dans le capot transparent. LES lampes blanches ne fonctionnent pas avec des piles usées les rouges oui. Donc au final tout fonctionne après soudage de l'interrupteur.

    Comentarios (1)
    Mostrar original
Show:

    Total 0 paginas

    Ir a la pagina

    recommendation for you
    • US$8.99
    • US$11.69
    • US$12.99
    • US$168.99
    • US$13.99
    • US$24.99
    • US$34.99
    • US$23.99
    • US$15.99
    • US$14.99
    • US$31.99
    • US$20.99
    • US$9.99
    • US$68.19